Breadmaking is an art one can spend a lifetime perfecting, and I have only just begun! However, I was so pleased with the way this Honey Wheat Bread turned out, I figured I’d share it with you.

Thanks to Julia Child, I’ve learned that the key to getting a nice crust is steam during the first 5-8 minutes of baking! To achieve this, I used Julia’s trick of super-heating a brick on top of the stove, then placing that brick into a pan of water in the bottom of the oven, creating a burst of steam. Another tip from Julia is to line the upper oven rack with ceramic tiles to use as a baking surface.

There are so many possible variations to this recipe and approach, but here’s what I did this time…

Ingredients

• 14 ounces bread flour
• 6 ounces whole wheat flour
• 10 ounces water (lukewarm)
• 4 ounces honey
• 2 teaspoons salt
• 1 teaspoon active dry yeast

Preparation

I’ve found that the easiest way to mix the ingredients is by weight. Using a good digital kitchen scale, equipped with a “tare” function makes the job easy. Place the bowl on the scale and press the “tare” button to reset the weight to zero. Add each ingredient slowly until the scale readout shows the desired number of ounces. Press the “tare” button after adding each ingredient so you’re measuring from zero each time.

Mixing can be done using either a food processor equipped with a dough blade, or an electric mixer. Of course, you can do it by hand too, but I will assume for these instructions that you’ll be using one of the previously mentioned tools.

1. Add all of the dry ingredients to the food processor or mixer. Mix briefly to blend.
2. With the food processor or mixer running, add the liquid (water and honey, combined) slowly.
3. If using an electric mixer, mix on medium speed for about 10 minutes.  If using a food processor, mix using the “dough” setting until the dough starts to form a ball, then continue mixing for about 45 seconds to 1 minute.
4. Place the dough in a lightly oiled bowl and let it sit at room temperature (around 70 degrees) for about 2 hours to rise, until doubled in size. The time will vary based on temperature and humidity. You can also use lower temperatures to slow down the rising process. For example, I sometimes make the dough in the evening and then leave it in the refrigerator to rise until morning.
5. Punch down and kneed the dough, then form it into a ball again (for a boule shaped loaf, or form into other shapes as desired).
6. Allow dough to rise for another hour.
7. At least 20 minutes before baking, preheat your oven to 400 degrees.
8. About 10 minutes before baking, start heating your brick on the top burner over a high flame. Make sure you have tested moving the brick before this (I use two sets of metal tongs).
9. Rub extra virgin olive oil on the dough, then use a razor blade or very sharp knife to make slashes in a pound sign (#) formation on the top of the dough.
10. Fill a 9 x 4 inch baking pan with water about an inch deep, then place in the bottom of your oven.
11. Carefully pick up the brick and place it in the pan of water. Be careful, as this will cause a lot of steam!
12. Place the formed dough on the ceramic tile, in the upper third of the oven.
13. Bake for 30 minutes at 400 degrees, removing the water pan after the first 5-8 minutes.
14. Reduce temperature to 375, then bake another 10-15 minutes, until the crust is golden brown. You can also use an instant thermometer to check the internal temperature. The bread is done when the internal temperature reaches about 200 degrees.
15. Remove the bread and allow it to cool on a wire rack for at least 20 minutes.